Energy UNITS FOR LIFT TABLE one
General Description
This electrical power unit is created solely for your tiny lift table,Consisting of substantial strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has been widely utilized within the industry of logistic products such as minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed by the solenoid valve with the speed controlled from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Common Description
This energy unit is designed solely for your medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the speed managed by the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is minimize, the lowering motion is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE three
Common Description
This electrical power unit is built solely for the large lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve and also the speed managed by a strain compensated flow handle valve.
Power UNITS FOR LIFT TABLE four
Standard Description
This energy unit is made solely to the massive lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is 
actived through the solenoid valve and also the speed controlled from the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power supply is cut, the decreasing movement is controlled through the manual override function.
Exclusive Notes
one. This energy unit is of S3 duty cycle, which might only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all the hydraulic components concerned just before installation of the energy unit.
3. Viscosity in the oil shoud be 15~46 cst,which should really also be clean and free of charge of impurities.N46 hydraulic oil is advisable.
4. Oil transforming is needed following the first 100 operation hrs,afterwards the moment every 3000 hours.
five. The power unit proven is designed to be mounted vertically.
